T. Ching, Y.-C. Toh, M. Hashimoto
Adv. Eng. Mater., 22(2020) 1901109.
Of the three types of 3D printers, light-based printers can print the smallest features, with channels down to about 20 µm, compared with roughly 300 µm for inkjet and extrusion printers. Low-cost versions are now common in research labs. They come in three main types: laser-scanning printers draw each layer with a moving laser spot, DLP printers project a whole layer at once using an array of tiny mirrors, and LCD printers shine light through a screen that blocks or passes light pixel by pixel.
These printers build a part layer by layer by curing liquid resin with light. A channel is a hollow space, so while printing, it is filled with liquid resin. When the printer cures the layer above the channel, some light passes through and can cure the trapped resin, clogging the channel. Even if the channel stays open, the leftover resin has to be flushed out. In a branching network, the flushing fluid takes the easiest path and leaves resin behind in the narrow branches. With the printer I used, a single-piece channel of 400 µm could not be printed reliably.
Instead of printing the network in one piece, I broke it into simple parts that are easy to print, printed each part with open channels, and then assembled them with screws. The parts are made of a soft elastomer, so they seal against each other without leaking. With no roof over the channel, there is no trapped resin to cure by accident, and open channels are easy to rinse. This let me print channels as small as 75 µm wide and 90 µm tall on the same printer. By stacking sheets or fitting together cubes with chamfered edges, I built 3D networks that are very hard to print directly: branching vessel-like networks, a lattice with 54 branches, curved and helical channels, and a 3D mixer. The same approach worked with both standard resins and hydrogels.
This work was featured on the cover of Advanced Engineering Materials (March 2020).