T. Ching, Y. Li, R. Karyappa, A. Ohno, Y.-C. Toh, M. Hashimoto
Sens. Actuators B Chem., 297(2019) 126609.
Different types of printers face different challenges when it comes to 3D printing microfluidic devices. Generally speaking, there are three types of 3D printing technology: light-based (vat photopolymerization), inkjet-based, and extrusion-based. Here I focus on the challenges of printing microfluidic devices with extrusion-based 3D printing.
An extrusion printer builds a device by stacking filaments layer by layer. For microfluidics, this causes three problems: gaps between filaments can leak, the roof over a channel can sag or collapse because it is printed over empty space, and the rough surfaces make the device hard to see through.
Instead of printing the whole device, I asked what actually needs to be printed. If you look at a cross-section of a microfluidic device, most of it is just flat material above and below the channel. Only the channel walls need a custom shape. So I printed only the walls, using a direct ink writing (DIW) printer to lay down silicone sealant onto a flat PMMA sheet. After it cured, I placed a second sheet on top and clamped them together with screws. This avoids all three problems: there is no printed roof to collapse, the soft silicone seals against the sheets without leaking, and the smooth prefabricated sheets keep the device clear for imaging.
Using this approach, I built most of the common microfluidic components: mixers, cell chambers, and droplet generators, with channels as small as 32 µm. Because the parts are held together with screws instead of permanent bonding, I could stack five sheets into a four-layer gradient generator, and take it apart again for cleaning. Pressing on one spot with a screw-driven stud turned a channel into a valve or an adjustable orifice. Tightening it shrank the droplets from about 800 µm to 140 µm without changing the volumetric flow rates. Finally, since the bottom sheet can be almost anything, I printed channels directly onto an Arduino circuit board, where a salt solution lit up LEDs as it reached each electrode, and onto a cell culture membrane to grow skin cells at an air-liquid interface.
Y., Kento, W. Zhou, T. Ching, S. Y. Huang, and M. Hashimoto. "Ultra‐deformable and tissue‐adhesive liquid metal antennas with high wireless powering efficiency." Advanced Materials 33, no. 26 (2021): 2008062.
M., Elizaveta, T. Ching, J. Vincent, J. Shin, E. T. Tan, V. Taracila, F. Robb, M. Hashimoto, D. B. Sneag, and S. A. Winkler. "Dual-channel stretchable, self-tuning, liquid metal coils and their fabrication techniques." Sensors 23, no. 17 (2023): 7588.